How do you replace the string on a Homelite trimmer?

Lay the weed eater on a flat floor and switch it so the string spool is dealing with you. Draw close the spool with one hand and the string head that encloses it with the other. Rotate the spool counterclockwise to unscrew and separate it. Pull the spool out of the head, making sure that the spring remains attached to the spool.

How to Troubleshoot a 2-Cycle Homelite String Trimmer

  1. Use the screwdriver to gently pop the rubber spark plug boot off of the spark plug.
  2. Clean the spark plug with the toothbrush, gas, and rag.
  3. Let the spark plug and rubber boot grasp virtually a steel factor on the engine block.
  4. Replace the spark plug and repeat test returned if there isn’t any spark.

One can also ask, how do you eliminate the head of a clipper? Replacing a trimmer head is similar on gas and electric trimmers.

  1. Turn your weed trimmer off and allow it to cool completely.
  2. Wipe off the trimmer head with a store towel to take away grass clippings and debris.
  3. Remove the bump knob at the backside of the trimmer head.
  4. Pull the trimmer line spool out of the trimmer head.

One could also ask, are Homelite trimmers any good?

The Homelite UT33650 Fuel Trimmer is one of the least steeply-priced and so much common weed whackers we reviewed. It really works quality if you have a small yard, however it cannot manage much beyond that. With a 17-inch cutting swath, the dual-line head does a good task reducing grass and weeds.

What is the spark plug gap for a Homelite trimmer?

0.025 inches

Where is mannequin variety on Homelite trimmer?

Your Homelite equipment could have a model data plate located on the unit. It involves the mannequin variety (eg. UT10580A), serial number, and different mannequin information. Homelite chainsaws in general have the model variety plate positioned at the rear handle.

How do you adjust a Homelite carburetor?

How to Modify the Carb on a Homelite Blower Vicinity the blower on a flat workbench. Stumble on the three adjustment screws found at the part of the carburetor, just below the air filter. Turn the “L” screw clockwise until the screw seats with the screwdriver. Turn the “H” screw clockwise until the screw seats. Rev the engine.